Cisco vs. Extreme Networks Switching Commands

Configuring VLANs:

Extreme – Create 2 VLANs and basic configuration
create vlan data
configure vlan data tag 2
configure vlan data ipaddress 10.0.2.1/24
create vlan voice
configure vlan voice tag 3
configure vlan voice ipaddress 10.0.3.1/24
enable ipforwarding

Cisco – Create 2 VLAN interfaces and basic configuration
vlan dat
vlan 2 name data
vlan 3 name voice
exit
configure terminal
interface vlan 2
ip address 10.0.2.1 255.255.255.0
no shutdown
interface vlan 3
ip address 10.0.3.1 255.255.255.0

Port Configuration
Extreme
-switch to pc on (vlan 2)
configure vlan data add port 4 untagged
-switch to phone (vlan 3) and PC (vlan 2)
configure vlan voice add port 4 tagged
configure vlan data add port 4 untagged
-switch to phone (vlan 3)
configure vlan voice add port 4 tagged
-switch to switch
configure vlan default add port 1 tagged
configure vlan data add port 1 tagged
configure vlan voice add port 1 tagged
Cisco (skipping configure terminal)

-switch to pc on (vlan 2)
interface g0/4
sw mode access
sw acc vlan 2
-switch to phone (vlan 3) and PC (vlan 2)
interface g0/4
switchport mode trunk
switchport trunk encapsulation dot1q
switchport access vlan 2
-switch to phone (vlan 3)
interface g0/4
switchport mode trunk
switchport trunk encapsulation dot1q
-switch to switch
interface g0/4
switchport mode trunk
switchport trunk encapsulation dot1q

Show Commands
Extreme – show port 4 information detail
Cisco – show interface g0/4
Extreme – show iproute
Cisco – show ip route
Extreme – show edp port all
Cisco – show cdp neigh
Extreme – show vlan
Cisco – show vlan
Extreme – show fdb
Cisco – show mac-address-table
Extreme – show config
Cisco – show run

Saving your work
Extreme – save
Cisco – write memory
Extreme – upload configuration vr vr-default 10.0.0.100
Cisco – copy start tftp

Starting over
Extreme – unconfigure switch all
Cisco – write erase